InwallTech Pro Gold M525.1LCR — Upside Down Mounting B-Stock — Each

Special buying opportunity!

There is NOTHING wrong with these speakers sound-wise. This is your opportunity to own some of the best speakers for inwall use at a remarkable price!

Here’s the deal:
We’ve come across a number of the speaker’s labels mounted upside down within the frame.
What this means:
These speaker are designed to fit perfectly in-between our standard 16″ on center stud bay system as a horizontal speaker. But only when you mount them in the “UP” or right side up position.
Why:
On the back of the speakers are the clamps (dog ears) that swing out and squeeze down to the back of the wall. BUT on one of the dog ears, the base is inset slightly to allow the dog ear on that side to swing out avoiding the stud. If you mount it upside down, then the one clamp bumps into the stud and oftentimes gets broken off by the installer turning too hard on the screw.

The speaker’s “LABELS” were applied upside down, so the installer assumes correct orientation, but it’s actually wrong, leading to either confusion or damage.

Here’s another opportunity…you don’t have to use these types of speakers as only center channel speakers. They’re great as left and right main speakers. Or surround speakers.

A performance benefit of the dual woofer design is that you get to add up the surface area of the drivers as they’re pushing the equal amount of air waves as an 8″ driver! It gets better! Because of the smaller size of the 2 drivers (over the single 8″), the reaction time is FASTER to react so you get a more responsive, dynamic sound.

Number of units affected: ~320 pieces (160 pairs)
Update: As of 5-5-14 ~150 piece (75 pairs) remain

Installation Tip for Starting Dog Ear Mounting

– LIFETIME WARRANTY
– Woofer: Dual 5.25″ Aluminum Laminate PP cone, rubber surround, 18 oz magnet, 1. 25″ voice coil, video shielded
– Tweeter: Swivel 30 degrees, 1″ Synthetic Dome, Ferro-fluid cooled, Neodymium magnet
– Crossover: Phonalic PCB board, 12dB woofer section, 12dB tweeter section
– Polyimide switch-auto protect reset switch, over power protection
– Overall Frequency response: 45 Hz – 24,000 Hz (+ – 9db)

– Upper Frequency limit -3db: 22,000Hz
– Sensitivity: 87dB at 1W/ 1M
– Maximum Thermal Rating: 125 watts
– Impedance: 8 ohm
– Overall Dimensions: 16 1/2″ x 8″ x 3 3/4″ (Will fit horizontally between standard stud
width)
– Cut out dimensions: 15 1/4″ x 6 5/8″ (It’s advised to NOT cut your opening until
you have the speakers in hand, a template is included with the speakers)

Frequently Asked Questions (FAQ):

Can I use these in drop ceiling tiles?
What’s so good about these speakers?
Can I play my iPod or computer speakers thru my in wall speakers?