Which Type of Speaker Selectors Should I Choose?
There are generally two types of speaker selectors: resistor based and autoformer based. On one hand, resistor-based speaker selectors are generally lower in cost

What is Impedance Matching?
To match impedance means to take a group of speakers (usually more than three pairs) and forcing the combined impedance of the speakers
Why Do I Need a Speaker Selector?
Typically, in a home situation we suggest a speaker selector with standard volume controls. That’s because you can turn off areas that you wouldn’t
Speaker Selector from One Receiver Set Up
Tom, Usually, we recommend using a separate receiver for your Theater room and the whole house system. This way, you can watch TV
Speaker Selector and Dual Voice Coil Speaker Question
Kevin, The speaker selector is what you need. It sounds like just a 4 pair selector will do. Something like this should be fine.
Speaker selector recommendations
Jim, To say the least…yes you`ll be pleased with the sound from those JAC6A’s, especially comparing them to the Radio Shack stuff. A speaker
System setup for in-ceiling speakers
Johnnie, You’re right about the best method. The speaker selector with non impedance matching volume controls is the way to go. As for the
Multiple speaker selector hookup
Ron, Generally not. Most all use floating ground type connections inside. And many receivers use series wiring when using A+B selectors. That doesn`t work
Receiver and speaker selector playback
Allan, You can use a simple Y-adapter or go as far as using an optical cable to one receiver and a coax digital cable
Speaker selector for whole house audio
George, You can do either. The advantage of the speaker selector and standard volume controls is that when you unselect a speaker area at
Volume control for a 12 gauge in-wall speaker
David, I don’t think any go below 14 gauge. However, all you need to do is trim a few strands off and it should
Pre-wired for in-ceiling speakers
Mike, I’d use two separate receivers, one for the theater and one for the whole house music. You use Y-adapters on all your sources (DVD,
Impedance matching for speaker sets
Ken, It is impedance matching selectable. So you can use it for two pairs. But keep in mind if you`re using it with others
Connecting speaker selector to receiver
Ken, We usually like to see a separate amp/receiver used for whole house music separate from the theater area. What happens if you use
Speaker selector for inside and outside speakers
Gina, You just need a speaker selector…it sounds like a 4 pair type. You’ll hook up the selector to just the A set of